RVF750 RC45 HRC Maintenance Schedule
| Item | Every Overhaul | Every 5,000km | Every 7,000km | Remarks |
| Cylinder block | I | Check for damage or wear | ||
| Cylinder head | I | Remove carbon build-up, lap valve against valve seat. If necessary, reface valve seat with valve seat cutter. Replace valve if it has roughness or local or abnormal wear on face. | ||
| Piston | I | R | Check for damage, wear or seizure, remove carbon build-up. | |
| Piston ring | I | R | Check for damage or abnormal or local wear. | |
| Piston pin | I | R | Check for wear or galling, replace with a new one whenever piston is to be replaced. Replace pin clips with new one whenever disassembled. | |
| Crankshaft | I | R | Check for damage and wear of journal and timing gear. | |
| Bearing journal/con-rod | I | R | Check for wear or damage. | |
| Connecting-rod | I | R | Check for wear or damage | |
| Camshaft | I | R | Check for damage or wear of camshaft profile. | |
| IN/EX valve | I | R | Remove carbon build-up, lap valves against seat. | |
| Valve springs | I | R | Check for wear or damage. | |
| Cylinder head gasket. | R | |||
| Spark plug | R | |||
| Fuel Pump | I | R | ||
| Ignition Coil Terminal | I |
I: Inspect and clean, adjust, lubricate or replace if necessary.
R: Replace
NOTICE
- The repair or replacement of any components that are work or damaged before the above intervals is not covered by the warranty
- Machine overhauling should be made every 1,000km (2 races for sprint race), or 1 race for endurance race.
- Change the con-rod bearing and the connecting-rod and the same time.